NABL & ISO/IEC 17025:2017 Calibration Reference Portal
Official Lab Services: multitek.in
Solutions for: Quality Heads & Auditors Shop Floor Inspectors Tool Room Technicians Engineering Students

What to Do After a Failed Torque Check

Failed Intermediate Torque Check: A Practical Decision Path Before the Wrench Returns to Service

Failed Intermediate Torque Check: A Practical Decision Path Before the Wrench Returns to Service

An intermediate check is useful only if the organization knows what to do when the result is bad. Repeating the test until the wrench finally produces a passing value is not a control strategy.

Step 1: Preserve the original observation

Record the failed reading, torque point, reference device, operator and date before making adjustments.

The first failed observation may later help establish when the wrench's behavior changed.

Step 2: Rule out obvious check-process problems

Confirm that the correct reference device and setup were used, that the checker is within its control status and that the procedure was followed.

A procedural error can create a false failure. Correcting a procedural mistake is valid, but do not delete the original observation. Document why the first result was rejected.

Step 3: If the failure remains credible, quarantine the wrench

Remove it from controlled tightening. Change the physical and electronic status so another operator cannot unknowingly use it.

ILAC-G24:2022 / OIML D 10:2022 supports the use of intermediate checks to maintain confidence in measurement equipment between calibrations. Once that confidence is lost, the tool should not simply remain in normal service.

Step 4: Decide whether formal calibration is needed

The answer depends on your procedure, risk and check capability. A formal calibration may be appropriate where the intermediate check indicates a meaningful shift, where the tool is used for high-consequence work or where the investigation needs stronger quantitative evidence.

ISO 6789-2:2017 covers formal calibration of hand torque tools and measurement uncertainty.

Step 5: Identify potentially affected work

Use the last known-good evidence point. That could be the previous calibration or a documented intermediate check.

Then identify where the wrench was used after that point. Work-order, tool-issue and production records can reduce the investigation scope.

Step 6: Assess impact using the actual as-found behavior

The size and direction of error matter. So do the process limit, fastening risk and any independent verification.

Do not conclude that all prior joints are defective simply because the check failed. Also do not conclude that they are acceptable simply because no field failure has been reported.

Step 7: Repair, adjust or replace based on the cause

A wrench that fails because of damage may need repair. A stable but shifted response may be adjusted. A repeatedly unstable tool may be a replacement candidate.

After intervention, establish acceptable performance before return to controlled service.

Step 8: Review whether the control plan needs to change

A failed check may show that the current calibration interval is too long, the check frequency is too low, storage is poor or tool selection is unsuitable.

ILAC-G24:2022 / OIML D 10:2022 recommends using historical data and check information when reviewing recalibration intervals.

Document the closure

The closure record should answer: what failed, what caused it, what work was reviewed, what was done to the wrench and what evidence supports release.

Frequently Asked Questions

Should I repeat a failed torque check?

You may repeat it to investigate technique or setup, but preserve the original failed result and document why any observation is rejected.

Does a failed intermediate check automatically mean previous work is defective?

No. It triggers an impact assessment. The outcome depends on the tool error, process requirements, risk and other evidence.

Can the wrench return to use after adjustment only?

Return to service should be based on evidence of acceptable measurement performance, not adjustment alone.

Turn every failed check into a controlled decision

Preserve evidence, quarantine the tool, assess prior work and require objective release evidence.

Authoritative Sources

Technical note: The decision path should be adapted to your organization's process risk, customer requirements and approved procedures.