Torque Tool Control: Intermediate Checks and Return-to-Service Records
A valid calibration date does not show what happened to a torque tool yesterday, last week or after a damaging event. That is the practical reason for intermediate checks.
Calibration dates alone do not show between-calibration behavior
ILAC-G24:2022 / OIML D 10:2022 recognizes intermediate checks as a way to maintain confidence that measuring equipment continues to function correctly between calibrations.
Intermediate checks can be particularly useful for frequently used, high-consequence or damage-prone torque tools, provided the check system itself is technically adequate.
Define the check before collecting data
An effective check procedure should specify:
- which tools are checked;
- when checks occur;
- the torque points used;
- reference equipment;
- loading technique;
- repetitions where appropriate;
- acceptance limits;
- actions for failures;
- required records.
The acceptance criterion should exist before testing begins. Deciding that a result is "probably acceptable" only after seeing it undermines consistency.
Control the checker, not only the wrench
A workshop torque analyzer with unknown status cannot create strong evidence about a wrench's stability.
ILAC P10 metrological traceability addresses metrological traceability, while ISO 6789-2:2017 addresses calibration of hand torque tools. A shop-floor check does not automatically need to be an accredited calibration, but the measurement chain behind the check still needs adequate control.
Record enough information to reconstruct the decision
A useful intermediate-check record normally includes the tool ID, date, operator, reference-device ID, check points, readings, defined limits, result, action taken and release authorization.
The record should let a later investigator answer: What was checked, with what, against which limit, by whom, and what decision was made?
Treat a failed check as information
Do not repeatedly exercise a failing wrench until it finally produces an acceptable reading and then record only the pass.
First rule out obvious procedural errors, but preserve the failed observations. If the result remains unacceptable, remove the wrench from controlled service and investigate.
The developing ISO 6789 Part 3 makes this topic more relevant
As of September 23, 2026, ISO is developing ISO 6789-3 development page focused on performance verification of hand torque tools. It is not yet a published International Standard.
Organizations do not need to wait for publication to improve basic check discipline. Separating intermediate verification from formal calibration, retaining results and defining escalation rules are already defensible practices.
Frequently Asked Questions
How often should intermediate torque checks be performed?
There is no universal frequency. Set it from risk, tool stability, use, history and the consequence of an undetected error.
Is an intermediate check the same as calibration?
No. A check monitors performance between calibrations; formal calibration establishes measurement performance using the applicable method.
What should happen after a failed check?
Quarantine the tool, preserve the result, investigate the cause and potential prior impact, and establish acceptable performance before controlled reuse.
Related Reading
Workshop check vs calibration | Calibration intervals | Out-of-tolerance investigation | ISO 6789 revision update
Build intermediate checks into your torque-control system
Detect drift before it becomes a larger production or maintenance investigation.
Authoritative Sources
Technical note: Specific check frequencies and acceptance limits must be technically justified for the actual application.
