NABL & ISO/IEC 17025:2017 Calibration Reference Portal
Official Lab Services: multitek.in
Solutions for: Quality Heads & Auditors Shop Floor Inspectors Tool Room Technicians Engineering Students

Torque Wrench Calibration for Aircraft Maintenance: Procedure and Records

 

Control begins before the wrench reaches the aircraft

Before issuing a torque wrench, verify its unique identity, current calibration status, usable range and any restrictions. The actual torque value and maintenance procedure must come from the applicable current aircraft/component maintenance data—not from a generic torque chart where approved task data specifies otherwise. FAA Part 145 requires manufacturer-recommended tools or an FAA-acceptable equivalent and requires tools used for airworthiness determinations to meet the calibration requirement. [9] EASA AMC specifically cites equipment used to measure torque figures as tooling that should be clearly identified and entered in the control register. [12]

What happens during calibration?

For hand torque tools, ISO 6789-2:2017 is a recognized technical standard that specifies calibration methods and the calculation of measurement uncertainty for indicating and setting hand torque tools. ISO currently lists the 2017 edition as published but scheduled for revision, with a replacement project under development, so organizations should verify the current edition when contracting calibration services. [34]

Calibration evidence should allow quality personnel to assess actual results rather than simply seeing a sticker saying “PASS.” FAA AC 145-9A recommends recording calibration method, results and actual readings at test points, particularly where calibration history is used to justify interval changes. [30]

How often should a torque wrench be calibrated?

There is no single annual interval established by the FAA/EASA provisions cited in this report. The interval should come from the applicable manufacturer's information and the organization's approved calibration system, supported by calibration history where changes are made. EASA AMC similarly starts with manufacturer instructions while permitting a different period where results justify it. [35]

If as-found results are outside permitted limits, initiate the organization's OOT impact-assessment process before returning the tool to service.

Use a photograph of a torque wrench on a calibration system from your own laboratory or calibration partner with written usage permission. Add an original diagram showing several example calibration test points along a wrench's working range; do not reproduce ISO's copyrighted procedure tables. A third visual can show a torque-wrench history chart using fictional calibration deviations.

Copyable torque-wrench control checklist

Check

Pass / details

Correct wrench for required range

 

Asset/serial ID legible

 

Current calibration status verified

 

Due date not exceeded

 

Limitations checked

 

Maintenance-data torque requirement confirmed

 

Required adapters/extensions accounted for per approved procedure

 

Tool ID recorded where organizational procedure requires it

 

Tool returned after use

 

Damage/overload reported

 

Next calibration certificate reviewed

 

As-found result acceptable

 

OOT investigation opened if required

 

The phrase “where organizational procedure requires it” is intentional: the cited FAA/EASA provisions do not establish a universal rule that every maintenance work card must contain the serial number of every calibrated tool used.